Water coolers are great for giving cool, clean water whenever you need it. However, if House Cleaning isn’t regularly done, it may become a breeding ground for germs.
Fortunately, you won’t need any harsh chemicals or expert assistance to complete the task. You’ll be good to go if you follow these House Cleaning instructions from Irvine on how to clean a water cooler.
How to Clean the Outsides of the Water Coolers
Your water dispenser’s exterior needs attention, too! Consider all the hands that have come into contact with it and what may happen within those taps. Thankfully, this is an effortless House Cleaning operation.
- Remove the plug from your water cooler.
- Remove the taps and tray from the sink and wash them with a House Cleaning solution of dishwashing liquid and warm water.
- Using a microfiber cloth, dry the taps and tray.
- Spritz the cooler’s exterior with vinegar, including the range where the tray would rest.
- Wipe away any filth and vinegar residue with the microfiber cloth.
- Replace the taps and tray in their original locations.
- Reconnect your water cooler.
How to Clean Top Loading Water Dispensers
It isn’t tricky to clean a top-loading water dispenser, but it’s best spared until when the water bottle is void and has to be removed anyhow. With your House Cleaning solution of choice, follow these House Cleaning steps by Irvine to clean and disinfect your water cooler.
- Disconnect the power line from the outlet to prevent electric shocks and avoid stumbling over electrical lines when moving around the cooler.
- Take the water bottle out and inspect for mildew or dirt build-up. Wipe it away with a paper towel if there is any.
- Scrub away thick filth using a scrub brush and a mixture of water and baking soda as a soft House Cleaning abrasive agent for obstinate places.
- Wipe off the area where the water bottle meets the dispenser with a clean sponge dipped in your House Cleaning solution.
- Next, remove the drip guard, as well as any tray that keeps your water cup below the faucet. Rinse them under the water, and then wipe them down with your cleaning solution.
- Through the top of the water dispenser, pour the leftover House Cleaning solution into the reservoir. Allow five minutes for the answer to settle before alternately emptying them via the spigots.
- Fill the reservoir with 2 liters of clean water and drain through each spout. Add another two liters of clean water, fatigue, and retest if you notice a baking soda taste or odor.
- Replace whatever pieces you removed and add a fresh bottle after you’re confident that the water is flowing clean.
- Lastly, remove the drip tray lid, wipe away excess water using a towel, then clean with bleach or a vinegar-water solution.
- Use a lint-free towel to dry your water cooler.
Always handle the new water bottle carefully and adequately wash your hands before touching it to prevent germ transmission.